As a product built to the DMR standard, Hyrera PD705LT is endowed with ergonomic design, all-round digital functions and remarkable quality to refresh your experience and enable you to be responsive to emergent situations.
The globally patented industrial design and antenna design ensure convenient operation and remarkable UHF performance.
Hytera PD705LT radios are strictly compliant with MIL-STD-810 C/D/E/F/G and IP67 standards, ensuring outstanding performance even in harsh environments.
With the combined application of narrowband codec and digital error-correction technologies, Hytera PD705LT radios are capable of ensuring you superior voice in noisy environments or at the edge of the coverage area. In addition, the adoption of the AGC technology also optimizes your voice. With built-in 1W speakers, Hytera PD705LT radios ensure clear and crisp voice communication.
Compared with analog radios, Hytera PD705LT radios can obtain an extra 40% operation time.
Higher Spectrum Efficiency, Higher Channel Capacity
Benefiting from the TDMA technology, Hytera PD705LT radios allow twice the channels based on the same spectrum resource. This is a big help to relieve the stress of increasing shortage in spectrum resource.
Dual-slot Pseudo Trunk
With this feature, the free slot can be allocated to a member that needs to communicate, effectively enhancing frequency efficiency and allowing you to communicate timely under emergency situations.
Dual Modes (Analog+Digital)
Hytera PD705LT radios can operate in either analog or digital mode. They are compatible with the prevalent analog system, ensuring a smooth analog-to-digital transition.
Versatile Voice Calls
Intelligent signaling of Hytera PD705LT radios support various voice call types, including Private Call, Group Call , All Call and Emergency Call.
Various Analog Signaling Types
Hytera PD705LT radios support various analog signaling types (HDC1200, DTMF*, 2-Tone and 5-Tone), various squelch control types (CTCSS/CDCSS), thus providing higher function expansion capacity to the analog world.
Hytera PD705LT radios support One Touch features that comprise of Text Message, Voice Calls and Supplementary Services.
Hytera PD705LT radios support scanning of pure Analog voice and signaling, pure Digital voice and data, and also mix mode scan that comprise of Analog and Digital activities.
|Frequency Range||UHF1: 400-470MHz|
|Zone Capacity||3 (each with a maximum of 16 channels)|
|Operating Voltage||7.4 V|
|Battery Life||Analogue: about 11 hours|
|Digital: about 16 hours|
|Dimensions||125 X 55 X 35mm|
|Frequency Stability||±1.5 ppm|
|Sensitivity (Analogue)||0.3uV (12dB SINAD);0.22 uV (Typical) (12dB Sinad)|
|0.4uV (20dB Sinad)|
|Sensitivity (Digital)||0.3uV /BER5%|
|Adjacent Selectivity||TIA-603 – 60 dB at 12.5 kHz / 70 dB at 20 and 25 kHz|
|ETSI – 60 dB at 12.5 kHz / 70 dB at 20 and 25 kHz|
|Spurious response rejection||TIA-603 – 70 dB at 12.5/20/25 kHz|
|ETSI – 70 dB at 12.5/20/25 kHz|
|Inter-Modulation||TIA-603 – 70 dB at 12.5/20/25 kHz|
|ETSI – 65 dB at 12.5/20/25 kHz|
|Hum & Noise||40 dB at 12.5 kHz|
|43 dB at 20 kHz|
|45 dB at 25 kHz|
|Rated Audio Power Output||0.5W|
|Rated Audio Distortion||<3%|
|Conducted Spurious Emission||<-57dBm|
|RF Power Output||UHF1/UHF2 High Power: 4W|
|UHF1/UHF2 Low Power: 1W|
|VHF High Power: 5W|
|VHF Lower Power: 1W|
|FM Modulation||11K0F3E @ 12.5KHz|
|14K0F3E @ 20KHz|
|16K0F3E @ 25KHz|
|4FSK Digital Modulation||12.5KHz Data Only: 7K60FXD|
|12.5KHz Data & Voice: 7K60FXW|
|Conducted/Radiated Emission||-36dBm<1GHz; -30dBm>1GHz|
|Modulation Limiting||±2.5KHz @ 12.5KHz|
|±4.0KHz @ 20KHz|
|±5.0KHz @ 25KHz|
|FM Hum & Noise||40dB @ 12.5KHz|
|43dB @ 20KHz|
|45dB @ 25KHz|
|Adjacent Channel Power||60dB @ 12.5KHz|
|70dB @ 20/25KHz|
|Audio Response||+1 ~ -3dB|
|Digital Vocoder Type||AMBE++or SELP|
|Digital Protocol||ETSI-TS102 361-1,-2,-3|
|Operating Temperature||-30°C ~ +60 °C|
|Storage Temperature||-40°C ~ +85°C|
|ESD||IEC 61000-4-2 level 4|
|±8kV (contact) ±15kV (air)|
|American Military Standard||MIL-STD-810 C/D/E/F/G|
|Dust & Water Intrusion||IP67 Standard|
|Humidity||Per MIL-STD-810 C/D/E/F/G Standard|
|Shock & Vibration||Per MIL-STD-810 C/D/E/F/G Standard|